|
|
|
|||||||
| Pushrod Tech/Performance External Engine | Internal Engine | Pushrod Tech Topics Only | Performance Results |
 |
|
|
Thread Tools | Display Modes |
|
#1
11-12-2009, 01:13 PM
|
||||
|
||||
Anyone here insatll a Mcleod Bell housing on a T5?
Is it a biotch? They have to be perfectly lined up correct?
McLeod steel Bellhousing #8660- SFI-Approved -Ford Small Block 4/5/6-Speed     
__________________
HPMustangs.com Staff 2001 Bullitt MPH Built shortblock MPH stage 2.5 Heads MPH Blower cams Vortech YSI Full Return Fuel System Tremec T-56 6 Speed Tuned by Kevin @ Wicked Motorsports 
|
|
#2
11-12-2009, 08:42 PM
|
||||
|
||||
|
don't think they are that bad just make sure you have the t-5 locating ring for it if thats the tranny you are using looks like they are in the pic
__________________
Jesus can walk on water....But Chuck Norris can swim on land!! 
|
|
#3
11-16-2009, 05:49 PM
|
||||
|
||||
|
[QUOTE=Snipes;72811]Is it a biotch? They have to be perfectly lined up correct?
McLeod steel Bellhousing #8660- SFI-Approved -Ford Small Block 4/5/6-Speed QUOTE] I've done Lakewood one piece bellhousings, which are a bitch and generally require offset dowels. I got lucky with mine this time and it went together without offsets. The Mcleod units have changeable tranny adapters, which should make them less difficult to allign than the 1 piece unit.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
